Compaq AA-Q88CE-TE - Manual (Page 299)

RTR Utility Error Messages
%RTR-E-RTRALRSTA, RTR already started
Explanation: RTR was already running when the "START RTR" command
was executed.
%RTR-S-RTRLOGENT, [A]
Explanation: The RTR LOG command was used to make an entry in the
RTR LOG
%RTR-I-RTRNOTRUN, RTR not running
Explanation: Message created specifically for the STOP RTR command
if RTR is not currently running, so that the IVP does not report a fatal
message.
%RTR-E-RTRNOTSTA, RTR not running
Explanation: RTR had not been started when a command was issued which
requires RTR to be running.
%RTR-S-RTRRCHSTART, RTR remote client handler started
Explanation: Indicates that remote client handler has been successfully
started after issuing a "START REMOTE_CLIENT_HANDLER" command.
%RTR-S-RTRRCHSTOP, RTR remote client handler stopped
Explanation: Indicates that the remote client handler has been successfully
stopped after issuing a "STOP REMOTE_CLIENT_HANDLER" command.
%RTR-S-RTRSTART, RTR started on node [A][A]
Explanation: Indicates that RTR has been successfully started after issuing
a "START RTR" command.
%RTR-S-RTRSTOP, RTR stopped on node [A][A]
Explanation: Indicates that RTR has been successfully stopped after issuing
a "STOP RTR" command.
%RTR-E-RTRWASSTO, RTR has been stopped
Explanation: RTR had been stopped when the command when a command
was issued which requires RTR to be running.
%RTR-S-SETTRANDONE, %ld transaction(s) updated in partition [A] of facility
[A]
Explanation: The requested set transaction command was successfully
performed.
%RTR-W-SETTRANROUTER, Cannot process this command, coordinator router
is still available
Explanation: RTR SET TRAN command cannot change because router is
still available.
RTR Utility Error Messages D–23