Compaq AA-Q88CE-TE - Manual (Page 216)

SHOW JOURNAL
SHOW JOURNAL
Display information about current RTR journal files.
Format
SHOW JOURNAL
Command Qualifiers Defaults
/CLUSTER /NOCLUSTER
/FILENAMES /NOFILENAMES
/FULL /NOFULL
/NODE[=node-list] /NODE=default-node-list
/OUTPUT[=file-spec] /OUTPUT=stdout
Description
The SHOW JOURNAL command shows the disks where the RTR journal files reside,
and (optionally) the maximum and allocated number of blocks for each journal
file and the journal file name.
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither /NODE nor /CLUSTER is specified then the command is executed on the
nodes specified by the latest SET ENVIRONMENT command. If no SET ENVIRONMENT
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/FILENAMES
/NOFILENAMES (D)
/FILE adds the journal filenames to the display.
/FULL
/NOFULL (D)
/FULL adds to the display the maximum and allocated number of blocks for each
journal file.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in node-list . If
node-list is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file file-spec . If
/OUTPUT or file-spec is omitted then the standard or default output is used.
6–140 RTR Command Line Interface