Compaq AA-Q88CE-TE User Manual
Page 177
MONITOR
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/COUNT=nr-updates
/COUNT=infinite (D)
Specifies how many times the RTR utility updates the screen before exiting or
returning to the
RTR>
prompt.
The default is that RTR updates the screen until CTRL-Z, CTRL-Y or another
RTR command is entered. The
/COUNT
qualifier may be used when the
/OUTPUT
qualifier is being used to redirect output to a file. In this case,
nr-updates
specifies how many screen images are written to the file.
/FACILITY=facility-name
/NOFACILITY (D)
Specifies the name of the facility to be monitored. This is only meaningful if at
least one facility counter is displayed.
/IDENTIFICATION=process-id
/NOIDENTIFICATION (D)
Specifies the hexadecimal process-id of the process to be monitored. This is only
meaningful if at least one process counter is to be displayed.
/INTERVAL[=delay-seconds]
/INTERVAL=2 (D)
Specifies how frequently RTR updates the screen.
Delay-seconds
is the number
of seconds that RTR waits after completing one screen update before starting the
next. Note that the interval between updates will always be slightly longer than
Delay-seconds
, depending on the complexity of the display and the number of
nodes being monitored.
/LINK=link-name
/NOLINK (D)
Specifies the node name for the link to be monitored. This is only meaningful if
at least one link counter is to be displayed.
/NODE=node-list
/NODE=default-node-list (D)
Specifies the names of the nodes to be monitored. If
node-list
is omitted then
the local node is monitored.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file
file-spec
. If
/OUTPUT
or
file-spec
is omitted then the standard or default output is used.
/PARTITION=partition-name
/NOPARTITION (D)
Specifies the names of the partitions to be monitored. Partitions names have the
form
node$facility$partition-id
.
/RESUME
/NORESUME (D)
Re-executes the last MONITOR command. The qualifiers /OUTPUT, /INTERVAL
and /COUNT may be used with /RESUME. All other qualifiers are ignored. This
RTR Command Line Interface 6–101