Compaq AA-Q88CE-TE - Manual (Page 297)

RTR Utility Error Messages
%RTR-S-PRTNCREATED, Partition created
Explanation: The requested partition was successfully created.
%RTR-S-PRTNDELETED, Partition deleted
Explanation: The requested partition was successfully deleted.
%RTR-S-PRTNEWFPOLS, Failover policy set
Explanation: Status indicating successful change to the partition failover
policy.
%RTR-S-PRTNEWPOLWAIT, Failover policy stored - awaiting servers before
taking effect
Explanation: Status indicating successful change to the partition failover
policy, but the change will only take effect once servers have been started.
%RTR-S-PRTNEWPRIO, Backend priority set
Explanation: Status indicating successful change to the backend priority.
%RTR-S-PRTNEWPRIWAIT, Backend priority stored - awaiting servers before
taking effect
Explanation: Status indicating successful change to the backend priority,
but the change will only take effect once servers have been started.
%RTR-E-PRTNODNOTDEF, No definition found for a node in the list - see log
file
Explanation: Status indicating absence of a definition for a node named in
list of back ends for the partition.
%RTR-E-PRTNODNOTLST, Local node must be in the list of back end nodes
Explanation: Status indicating erroneous absence of the local node from the
ordered list of back ends for the partition.
%RTR-E-PRTNOSRVRS, Partition has no servers - please start servers and
retry
Explanation: Cannot perform the requested action until servers are
attached to the partition. Start servers and retry.
%RTR-E-PRTNOTBACKEND, Partition commands must be entered on a
backend node
Explanation: Restriction: partition commands must be entered on a
BACKEND node.
%RTR-E-PRTNOTSUSP, Unable to resume partition that is not suspended
Explanation: Status indicating completion of partition resume command
where the target partition was not suspended.
%RTR-S-PRTRESUME, Partition resumed
Explanation: Status indicating successful completion of partition resume
command. Transaction presentation is now enabled.
%RTR-S-PRTRSRTRCVY, Partition recovery initiated
Explanation: Completion status indicating that partition recovery was
manually initiated by the operator.
RTR Utility Error Messages D–21