Compaq AA-Q88CE-TE - Manual (Page 232)

SHOW PROCESS
SHOW PROCESS
Display information about processes which are using RTR.
Format
SHOW PROCESS
Command Qualifiers Defaults
/CLUSTER /NOCLUSTER
/COUNTER[=counter-name] /NOCOUNTER
/FULL /NOFULL
/IDENTIFICATION=process-id /NOIDENTIFICATION
/NODE[=node-list] /NODE=default-node-list
/OUTPUT[=file-spec] /OUTPUT=stdout
Description
The SHOW PROCESS command displays information about the processes using RTR.
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither /NODE nor /CLUSTER is specified then the command is executed on the
nodes specified by the latest SET ENVIRONMENT command. If no SET ENVIRONMENT
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/COUNTER[=counter-name]
/NOCOUNTER (D)
Specifies that the process counters are also to be displayed. counter-name is the
name of the counter to be displayed. If counter-name is omitted then all counters
will be displayed. counter-name may contain wild card characters.
/IDENTIFICATION=process-id
/NOIDENTIFICATION (D)
Specifies the process about which information is required. The default
(/NOIDENTIFICATION) displays all processes using RTR.
/FULL
/NOFULL (D)
Equivalent to specifying /COUNTER .
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in node-list . If
node-list is omitted then the command is executed only on the node where the
command was issued.
6–156 RTR Command Line Interface