Compaq AA-Q88CE-TE - Manual (Page 301)

RTR Utility Error Messages
%RTR-E-TOOMANCHN, Too many channels
Explanation: Displayed when a "SYS$DCL_TX_PRC" command is issued
and the channel table is full.
%RTR-F-TOOMANDIS, Too many disks specified in journal definition
Explanation: Explanation: Too many disks were specified in journal
definition. The RTR journal can be defined to use up to a maximum of sixteen
disks.
User Action: Issue the CREATE JOURNAL command specifying a smaller
number of disks.
%RTR-F-TOOMANREC, Too many records for one entry in the journal
Explanation: An attempt was made to write more than 65534 records to one
entry (transaction) in the journal.
%RTR-E-TOOMANYOBJ, Max DECnet objects exceeded, raise and retry
command
Explanation: The executor limit on the number of DECnet connect objects
has been exceeded. Please use NCP to raise the maximum number of objects
on this node.
%RTR-E-TOOMANYSELITM, More then one selitm specified in data-class :[A]
Explanation: More then one selitm specified in data-class on call to
rtr_request_info.
%RTR-E-TOOMUCDAT, Too much data to be monitored
Explanation: An attempt was made to monitor too many processes. Please
submit an SPR.
%RTR-E-TOOSMALL, [A] may not be less than [A]
Explanation: The value of qualifier [A] must be greater or equal to [B].
%RTR-I-TRMCENTRYNFND, No termcap-entry for terminal-type : [A].
Explanation: No such entry was found in the termcap file for the terminal
type. For UNIX platforms, please check that the environment variables
"TERM" and/or "TERMCAP" (if used) are correct. Also check that the
TERMCAP file (if used) has a valid entry for your terminal type. (NOTE:
These entries are case-sensitive.) The default terminal type is vt100.
%RTR-E-TRNOTALL032, Not all routers are at the minimum required version
of V3.2
Explanation: Cannot perform the requested action since not all routers are
at a minimum version of V3.2
%RTR-F-TRUNCATED, Buffer too short for msg
Explanation: Buffer too short for message, message truncated.
%RTR-F-TXNOTACT, No tx currently active on chan
Explanation: No transaction currently active on channel.
%RTR-E-UICNOTGRP, UIC [A] cannot be used in GROUP mode
Explanation: A "SET MODE/GROUP" command was issued while running
under system UIC (group one). System UIC’s cannot be used in group mode.
RTR Utility Error Messages D–25