Compaq AA-Q88CE-TE - Manual (Page 18)

Introduction
1.5 Remote Commands
This command starts RTR on the three nodes.
Note
The /CLUSTER and /NOCLUSTER command qualifiers refer to cluster
support. These qualifiers are for operating systems that fully support
clustering. Use of the /CLUSTER qualifier on systems that do not have
clustering causes the relevant command to be executed on the local node
only. For example Windows 95 systems do not support clustering.
If several commands need to be executed remotely on the same nodes then the
set environment command can be used to save typing.
For example:
% RTR
RTR> set environment/node=(nodeA, nodeC)
RTR> stop rtr
This example shows the use of the set environment command to stop rtr on
Node A and Node C. More details concerning the commands used in the above
examples are contained in Section 6.2.
1–4 Introduction