Cabletron Systems CSX400 - Manual (Page 85)

Configuring the Frame Relay Protocol 4-21
CSX WAN Configuration
b. Choose All Interfaces to apply changes to all WAN interfaces on the
device that are configured for Frame Relay.
2. To change the State, click on the selection box and a pull down menu will
appear. Select either ansiT1-617-D or noLmiConfigured, and release the
mouse button. The new configuration will appear in the text box.
3. To change the Polling Interval, highlight the current value in the text box, type
a new value (from 5-30 seconds) in the text box, and press Enter/Return.
4. To change the Full Enquiry Interval, highlight the current value in the text
box, type a new value (from 1-255) for the number of successive intervals that
must pass before a Full Enquiry message is sent, and press Enter/Return.
5. To change the Error Threshold, highlight the current value in the text box,
type in a new value (from 1-10) for unanswered status enquiries that must
pass before the interface is declared to be down, and press Enter/Return.
6. To change the Monitored Events, highlight the current value in the text box,
type a new value (from 1-10) for the number of status polling intervals over
which the error threshold is counted, and press Enter/Return.
7. To change the Max Virtual Circuits, highlight the current value in the text box,
type a new value (between 1 and 4 on a CSX200 device, between 1 and 32
for each interface on a CSX400) in the text box, and press Enter/Return.
8. Click on to save the changes or to restore the original
configuration.