Welch Allyn SureTemp PlusModule - User Manual - Manual (Page 76)

Setup SureTemp Plus Module OEM Implementation
76 Confidential Welch Allyn OEM Technologies
Setup
Personal Computer Requirements
The SureTemp Plus PC software is intended to operate on Microsoft® Windows® 9X /NT /2000 /
XP software on a personal computer with the following minimum requirements:
• 200 MHz Pentium, 32MB of RAM, 10MB of hard drive space.
Software Installation
To install the software on a PC, do the following:
1. Insert the SureTemp Plus PC software CD into the computer’s CD-ROM drive.
2. Follow the screen instructions to install the software.
If the SureTemp Plus PC software setup program does not start automatically, follow these steps:
1. Open My Computer, Windows Explorer, or File Manager.
2. Double-click on the CD drive letter (usually D:, E:, or F:).
3. Double-click Setup.exe.
4. Follow the screen instructions to install the software.
Hardware Installation
To set up the SureTemp Plus Developers Kit hardware (Figure 11), do the following;
1. Plug the serial cable male connector into the 9-pin D-type serial jack on the back panel of
the SureTemp Plus Evaluation Platform.
2. Plug the serial cable female connector into the computer serial port.
3. With the power supply AC cord unplugged, connect the other plug of the power supply
into the power jack on the back of the SureTemp Plus Evaluation Platform.
4. Plug the power supply AC cord into a 110 VAC wall outlet (or 220 VAC, depending on
transformer configuration and available AC power).
5. At the computer, click on the SureTemp Plus icon (or click the start button and locate the
program) to start the program.