Na vigation system, Previous destinations – Mercedes-Benz CLS-Class 2011 COMAND Manual User Manual
Page 82
X
Select
Destination
in the navigation
menu bar using the :=;
buttons and press the 9 button to confirm.
X
Select
From Memory
and press the 9
button to confirm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
X
Option 1 – destination memory list with
character bar: proceed as described in the
"Entering characters" section (
Y
page 23).
X
Option 2 – destination memory list as a
selection list: select a destination using
the 9: buttons and press the 9
button to confirm.
The address data appears for the selected
entry.
X
Select
Delete
and press the 9 button to
confirm.
A prompt appears asking whether you wish
to delete the destination.
X
Select
Yes
or
No
and press the 9 button
to confirm.
If you select
Yes
, COMAND deletes the
destination. You see a message to this
effect.
If you select
No
, the process will be
canceled.
i
If the navigable address data for the
destination being deleted is also assigned
to an address book entry, COMAND will
also delete this data from there. If the
corresponding address book entry does
not contain any further data, such as
telephone numbers, COMAND deletes the
entire address book entry.
Previous destinations
Introduction
COMAND automatically stores the previous
destinations for which the route calculation
was started. If the memory is full, COMAND
deletes the oldest destination. You can also
store one destination from the list of previous
destinations in the destination memory. It will
be stored there permanently.
Storing a destination permanently in
the destination memory
X
Proceed as described in the "From the list
of previous destinations" section
(
Y
page 78).
Storing the vehicle position in the list
of previous destinations
X
To switch on navigation mode: press the
Ø function button.
X
To show the menu: press the 9 button.
X
Select
Position
in the navigation menu
bar using the :=; buttons and
press the 9 button to confirm.
X
Select
Save Vehicle Position
and press
the 9 button to confirm.
COMAND stores the current vehicle
position as a destination in the list of
previous destinations.
Storing the crosshair position in the
list of previous destinations
Route guidance not active
A crosshair appears on the map if you have
moved the map manually. You can store the
crosshair position as a destination in the list
of previous destinations.
X
To show the menu: press the 9 button.
X
Select
Position
in the navigation menu
bar using the :=; buttons and
press the 9 button to confirm.
X
Select
Save Crosshair Position
and
press the 9 button to confirm.
80
Previous destinations
Na
vigation
system