Mercedes-Benz CLA-Class 2014 COMAND Manual - Manual (Page 97)

Route demonstration
You can see the route before starting your
journey. This function is only available when
the vehicle is stationary.
X To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select Route Route in the navigation system
menu bar by turning cVd the COMAND
controller and press W to confirm.
X
Select Route Demonstration Route Demonstration and press
W to confirm.
The map with the crosshair appears.
X To get to the destination: press W to
confirm the highlighted symbol.
X
To stop the route demonstration: con-
firm the Ë symbol by pressing W.
Example: route display stopped
:
Road name and city display when route
display has been stopped
; Distance of the crosshair from current
vehicle position
X
To get to the current vehicle position:
press W to confirm the symbol for the cur-
rent vehicle position.
X To change the map scale: select Scale Scale
and press W to confirm.
The scale bar appears.
X
Turn cVd the COMAND controller and
press W to confirm.
Recording the route
Notes
If you have activated COMAND and the SD
memory card has been inserted, you should
not take it out of the slot.
You can store up to 100 routes.
When you record a route, COMAND uses so-
called support points and displays the route
as a series of lines. If the route is then calcu-
lated, COMAND attempts to align the recor-
ded route with the digital map.
The support points of the route may not be on
a digitized road.
This is often the case for routes that have
been calculated using map data from other
sources.
Route guidance
95
Navig
atio
n
Z