Mercedes-Benz CLA-Class 2014 COMAND Manual - Manual (Page 34)

The example describes how to set the sur-
round sound for radio mode.
X
To switch surround sound on/off: press
the $ button.
The radio display appears. You will hear the
last station played on the last waveband.
X
Select Sound Sound by sliding VÆ and turning
cVd the COMAND controller and press W
to confirm.
X
Select Surround Surround and press W to confirm.
X Select Logic7 Logic7 ®® On On or Logic7 Logic7 ®® Off Off by turn-
ing cVd the COMAND controller and press
W to confirm.
Depending on your selection, surround
sound is switched on or off and the menu is
exited.
X To exit the menu without saving: press
the k back button or slide XVY the
COMAND controller.
i Please note the following: for the opti-
mum audio experience for all passengers
when Logic7 ® is switched on, the balance
should be set to the center of the vehicle
interior.
You will achieve the best sound results by
playing video DVD media.
MP3 tracks should have a bit rate of at least
128 kbit/s.
Surround sound playback does not func-
tion for mono signal sources, such as for
AM radio mode.
If radio reception is poor, e.g. in a tunnel,
you should switch off Logic7 ® , since it may
otherwise switch dynamically between
stereo and mono and cause temporary
sound distortions.
On some stereo recordings, the sound
characteristics may differ from conven-
tional stereo playback.
i The Logic7 Logic7 ®® On On function creates a sur-
round sound experience for every
passenger when playing stereo recordings,
for example. It enables optimum playback
of music and films on CD or video DVD with
multichannel audio formats, such as MLP,
dts or Dolby Digital. This results in sound
characteristics like those intended by the
sound engineer when the original was
recorded.
i If you select Logic7 Logic7 ®® Off Off , the sound sys-
tem plays the tracks as stored on the
medium. Due to the design of the
passenger compartment, an optimum
audio experience cannot be guaranteed for
all passengers.
Bang & Olufsen sound system
You can optimize the sound in the vehicle with
the Bang & Olufsen sound system and the
True True Image Image ™ sound technology. The Sound Sound
Mode Mode function enables you to focus the selec-
ted sound setting within the vehicle.
The example describes how to set the opti-
mum sound for radio mode.
Selecting the sound setting for True
Image™
X
Press a number key, such as $.
X Select Sound Sound by sliding VÆ and turning
cVd the COMAND controller and press W
to confirm.
X Select Bang&Olufsen Bang&Olufsen and press W to con-
firm.
A menu appears. A # dot marks the current
setting for True Image™.
X Select reference reference or surround surround and press
W to confirm.
R reference reference
32
Basic COMAND functions
At
a
gl
anc
e