beautypg.com

Rear se at en tertai nme nt sys tem, Basic functions – Mercedes-Benz CLA-Class 2014 COMAND Manual User Manual

Page 243

background image

X

To open the battery compartment:

remove battery compartment cover = on

the back of the remote control.

X

To do so, press down retaining lug ; and

take off battery compartment cover =.

X

Remove discharged batteries A from the

tray.

X

Insert the new batteries. Observe the polar-

ity markings on the batteries and battery

compartment when doing so.

Left-hand battery: the positive pole (+)

must face upwards.
Right-hand battery: the positive pole (+)

must face downwards.

X

To close the battery compartment:

insert battery compartment cover = start-

ing with retaining lugs ? into the battery

compartment and allow catch tab ; to

engage in place.

Replacing cordless headphone batter-

ies

The battery compartment is located on the

left headphone. The cordless headphones

require two type AAA, 1.5 V batteries.

X

To open the battery compartment: turn

battery compartment cover : counter-

clockwise and remove.

X

Remove the discharged batteries from the

tray.

X

Insert the new batteries. Observe the polar-

ity markings on the batteries and battery

tray when doing so.

X

To close the battery compartment:

replace battery housing cover : and turn

it clockwise until it engages.

If the batteries have been inserted cor-

rectly, the indicator lamp will light up green

when the headphones are switched on.

i

The operating duration of the headphones

with a set of batteries is up to 40 hours.

Basic functions

Using headphones

You can use the cordless headphones sup-

plied and/or up to two sets of corded head-

phones connected to the corresponding jack

of the rear-compartment screens

(

Y

page 237).

Information on the cordless headphones

(

Y

page 239).

Using the main loudspeakers

This function is available in conjunction with

COMAND.
You can use the vehicle loudspeakers to lis-

ten to a disc inserted in the rear-compartment

drive. To do so, at least one of the rear-com-

partment screens must be set to disc mode.

X

To set on COMAND: press the $ but-

ton, for example, to switch on an audio

mode.

X

Select

Audio

Audio

by sliding ZV the COMAND

controller and press W to confirm.

The Audio menu appears.

X

Select

Rear

Rear

by turning cVd the COMAND

controller and press W to confirm.

Basic functions

241

Rear

Se

at

En

tertai

nme

nt

Sys

tem

Z