Mercedes-Benz CLA-Class 2014 COMAND Manual - Manual (Page 104)

Displaying all traffic reports
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X Select Traffic Traffic in the navigation system
menu bar by turning cVd the COMAND
controller and press W to confirm.
X Select All All Messages Messages and press W to con-
firm.
A list is shown containing all roads, areas or
regions affected by traffic reports. Roads,
areas or regions not on the route also
appear in the list.
X To show a traffic report: select a road,
area or region and press W to confirm.
The traffic report is displayed. There may be
several traffic reports for the affected road.
You can find an example of a traffic report
here: (
Y
page 101).
X
To close a report: slide XVY the COMAND
controller.
Reading out traffic reports on the
route
Introduction
The read-aloud function is only available while
route guidance is active. It reads out traffic
reports affecting the current route.
You can select the following text reader prop-
erties:
R Language (
Y
page 45)
R
Text reader speed (
Y
page 44)
You can start the text reader function man-
ually or set it to automatic.
Starting the text reader function man-
ually
X To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X Select Traffic Traffic by turning cVd the
COMAND controller and press W to con-
firm.
X Select Read out all messages on Read out all messages on
route route and press W to confirm.
COMAND reads out the reports in
sequence.
i If there are no reports for the route, the
Read Read out out all all messages messages on on route route menu
item is shown in gray and cannot be selec-
ted.
X
To switch off the read-aloud function:
select Cancel Cancel Read-Aloud Read-Aloud Function Function and
press W to confirm or press the 8 but-
ton.
COMAND reads out the current report and
then exits the read-aloud function.
Automatic read-aloud function
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X Select Traffic Traffic by sliding ZV and turning
c V d the COMAND controller and press W
to confirm.
X Select Read Traffic Messages Auto‐ Read Traffic Messages Auto‐
matically matically and press W to confirm.
Depending on the previous state, switch
the option on O or off ª.
102
Traffic reports
Navi
gati
on