Mercedes-Benz CLA-Class 2014 COMAND Manual - Manual (Page 109)

X Select Yes Yes or No No and press W to confirm.
If you select Yes Yes , COMAND deletes the
destination. You will see a message to this
effect.
If you select
No No , the process will be can-
celed.
i If the navigable address data for the des-
tination being deleted is also assigned to an
address book entry, COMAND will also
delete this data from there. If the corre-
sponding address book entry does not con-
tain any further data, such as telephone
numbers, COMAND deletes the entire
address book entry.
Previous destinations
Introduction
COMAND automatically stores the previous
destinations for which route calculation has
been started. If the memory is full, COMAND
deletes the oldest destination. You can also
save a destination from the list of previous
destinations in the destination memory. It will
be stored there permanently.
Storing a destination permanently in
the destination memory
X
Proceed as described in the "From the list
of previous destinations" section
(
Y
page 70).
Storing the vehicle position in the list
of previous destinations
X To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X Select Position Position in the navigation system
menu bar by turning cVd the COMAND
controller and press W to confirm.
X Select Save Save Vehicle Vehicle Position Position and press
W to confirm.
COMAND stores the current vehicle posi-
tion as a destination in the list of previous
destinations.
Storing the crosshair position in the
list of previous destinations
A crosshair appears on the map if you have
moved the map manually (
Y
page 108). You
can store the crosshair position as a destina-
tion in the list of previous destinations.
X
To show the menu: press W the COMAND
controller.
X Select Position Position in the navigation system
menu bar by turning cVd the COMAND
controller and press W to confirm.
X
Select Save Crosshair Position Save Crosshair Position and
press W to confirm.
Deleting one of the previous destina-
tions
X To switch on navigation mode: press the
Ø function button.
X
To show the menu: press W the COMAND
controller.
X Select Destination Destination in the navigation sys-
tem menu bar by turning cVd the
COMAND controller and press W to con-
firm.
X Select From Last Destinations From Last Destinations and
press W to confirm.
The list of last destinations appears.
X Select the desired destination and press W
to confirm.
The destination address appears.
Previous destinations
107
Navig
atio
n
Z