Mercedes-Benz CLA-Class 2014 COMAND Manual - Manual (Page 74)

X To select a destination: press W the
COMAND controller once or several times.
If COMAND is unable to assign a unique
address, you will see either the address
entry menu with the destination address or
a selection list.
X
Select a destination by turning cVd the
COMAND controller and press W to con-
firm.
If the destination is within the limits of the
digital map, COMAND attempts to assign
the destination to the map.
If the destination can be assigned, you will
see the address entry menu with the
address of the destination. If not, you will
see the Destination From Map Destination From Map entry.
X To start route calculation: select Start Start
and press W to confirm.
Entering a destination using geo-coor-
dinates
X
To switch to navigation mode: press the
Ø button.
X To show the menu: press W the COMAND
controller.
X Select Destination Destination in the navigation sys-
tem menu bar by turning cVd the
COMAND controller and press W to con-
firm.
X Select Using Geo-Coordinates Using Geo-Coordinates and
press W to confirm.
An entry menu appears.
You can now enter the latitude and longitude
coordinates with the COMAND controller or
the number keypad (
Y
page 35).
X
To change a value: turn cVd the
COMAND controller.
X To move the mark within the line: slide
XVY the COMAND controller.
X
To move the mark between the lines:
slide ZVÆ the COMAND controller.
X To confirm the value: press W the
COMAND controller.
i If the selected position is outside the dig-
ital map, COMAND uses the nearest digi-
tized road for route calculation. You will see
the The co-ordinates are outside The co-ordinates are outside
the map area the map area message. If the selected
position is located over a body of water, you
will see the The destination is in a The destination is in a
body of water. Please select body of water. Please select
another destination. another destination. message.
Entering a destination using
Mercedes-Benz Apps
X To switch to navigation mode: press the
Ø button.
X To show the menu: press W the COMAND
controller.
X
Select Destination Destination in the navigation sys-
tem menu bar by turning cVd the
72
Destination entry
Navi
gati
on