Losi LOSB9567 - Manual (Page 8)

LOSB9501 Xcelorin Electronic Speed Control v1.0 Page 8
Selecting profiles
Notice that Profile #1 is set from the factory as the DEFAULT.
1. Turn the Transmitter on.
2. Turn the vehicle on.
3. With the ESC turned on and ready for operation, press and hold the setup
button until both the Yellow and Blue LEDs flash.
4. Release setup button.
5. The status LEDs flash to indicate the current profile setting.
LED status for each Profile below:
Profile 1 Yellow and Blue LEDs flash (default setting)
Profile 2 Yellow, Blue and Green LEDs flash
Profile 3 Yellow, Blue, Green and Red Flash
6. To make a change, quickly press the setup button, which will advance you to
the next profile.
9
7. When you are finished, press and hold the setup button for 2 seconds, the
four status LEDs will scroll and the new selection will be stored to the active
memory of the ESC.