Losi LOSB9567 User Manual
Page 11
LOSB9501 Xcelorin Electronic Speed Control v1.0
Page 11
To change the settings rearrange the small jumpers to the
desired settings.
To upload to the ESC do the following:
1. Ensure the transmitter and vehicle are turned off.
2. Make sure a battery pack is installed that has some
charge in it.
3. Connect the battery to the vehicle.
4. Turn the power on to the ESC, wait for the Blue (or
Blue/Yellow) LED to come on.
5. Disconnect the Signal wire for the ESC from the receiver.
6. Connect the Signal wire to the top of the QPC, ensure it is connected
correctly.
7. Pay close attention to the ESC LEDs. You will notice the Red LED flash, and
on the QPC the Red LED will come on. If you do not notice the ESC Red LED
flash, you can unplug the Signal wire from the QPC and reconnect to verify the
operation of the Red LEDs. Once you see the ESC flash Red and the QPC turn
on Red, the ESC has accepted the programming.
8. Disconnect the Signal wire from the QPC, turn off the power switch.
9. Reconnect the signal wire into the receiver.
10. The ESC has been updated and you are ready.