Losi LOSB9567 - Manual (Page 13)

LOSB9501 Xcelorin Electronic Speed Control v1.0 Page 13
Note: If you cannot get the ESC to Calibrate, you may need to reverse your
Throttle Servo on the transmitter.
3. Using the throttle trigger pull Full Throttle until the Green LED is ON solid.
4. Next push the throttle trigger to Full Brake until the Red LED is ON solid.
5. Now return the throttle trigger to the Neutral position and the Blue LED is
ON solid.
6. Turn off the vehicle/ESC power switch.
7. Turn the vehicle/ESC back ON; you are now ready to use the ESC.
Normal Operation
• After turning on the vehicle, the Blue LED will be on for normal operation.
• If reverse is active then you will notice the Yellow LED is also on.