Losi LOSB9567 User Manual
Page 7
LOSB9501 Xcelorin Electronic Speed Control v1.0
Page 7
Overriding the Active Profile
There are three (3) saved profiles within the ESC that were previously
described. To override a setting within the active profile, select a saved profile
that resembles your needs, or make further changes to the current profile.
Review the QPC and set the jumpers to your choice. You must make a choice
for each area of the QPC (Cutoff Voltage, Initial Acceleration, Throttle Limit,
Reverse Throttle Limit, Drag Brake, Frequency and Reverse Rotation).
For example if you have the ESC active profile set to Profile #1 (Default) and
would like Mid Initial Acceleration (from High) but would like nothing else
changed, place the jumpers on the following choices.
Cutoff Voltage – 3S LiPo
Throttle Limit – 0% (No limit)
Reverse Throttle Limit – 100% (No limit)
Initial Acceleration – Mid
Percent Drag Brake – 0%
Legacy or 2.4GHz – 2.4GHz
Reverse Rotation – Off
Then follow the instructions for using the Quick Programming Card. You can
change one setting at a time or any combination. Making the above change is
ONLY overriding the active profile. At any time, you can reset the ESC to
Profile #1 and the active profile is returned to the original Profile #1 settings.