Losi LOSB9567 - Manual (Page 15)

LOSB9501 Xcelorin Electronic Speed Control v1.0 Page 15
Connect the Xcelorin ESC and Sensored Motor
There are three wires from the ESC a Blue, Yellow and Orange, which are to be
connected to the motor.
Below see an Xcelorin Sensored Brushless motor, each wire should be
connected to a single motor lead. The order of connection is important and
when you are looking at the motor with the tabs up, the wires attach from left
to right in the following sequence: Blue on far left, Yellow to the center tab, and
Orange on the far right. Make certain there is not a short across any of the
motor connections. If shorted together, you will damage the ESC when the
batteries are connected.
- If the motor you are using runs backwards after installation, you can correct this
using the software program and selecting the Reverse Rotation feature.