Losi LOSB9567 - Manual (Page 29)

LOSB9501 Xcelorin Electronic Speed Control v1.0 Page 29
General Tab: Here you will find the following configuration settings:
Battery Type and Cutoff Voltage, Brake/Reverse, Motor Timing, Initial Acceleration, Percent
Drag Brake, ESC operating mode, Deadband adjustment, Braking Percentage, Throttle
Limit, Reverse Throttle Limit and Motor Rotation. All changes are done at your own risk.
Throttle Tab: This tab is disabled for crawler use.
Brake Tab: This tab is disabled for crawler use.
About Tab: Here you will see the Setup software version installed, and date of last
update. This will be helpful information should you have questions or support concerns.
Connection: This section is displayed on every Tab. There are two icons; one for the USB
connection, the other indicates the Electronic Speed Control connection. They are RED in
color when disconnected and GREEN on connection.
Note: Without an understanding of a specific function and reason, it is not recommended
that you make changes to the “default” configuration. There have been defaults selected
as a direct result of our testing. Changing of the configuration will be at your own risk.
Read Settings: Use of this button will read the current Electronic Speed Control (ESC)
configuration and present it on the current tabbed page only.
Send Setting: Use of this button will send (write) the current selected configuration to
the ESC for the current tabbed page only.
Upgrade Firmware: Use of this button will begin the firmware upgrade process. The
following pop-up will be displayed, and you need to select the location of the firmware
update file. You may cancel this process here without any effect to the ESC firmware.