Losi LOSB9567 - Manual (Page 12)

LOSB9501 Xcelorin Electronic Speed Control v1.0 Page 12
Note: If you should happen to lose any of your jumpers they are the
same jumpers used with computers and easily obtained at a computer
store.
ESC Warning LEDs
• If the Battery low voltage cutoff (LVC) is reached, the Red LED will blink.
• The Red LED will automatically stop blinking should the battery voltage
recover above the chosen Low Voltage Cutoff.
• If the ESC has detected a thermal overload, the Yellow LED will blink. Let the
ESC cool down.
Setup/Calibration to Transmitter
To perform the setup/calibration between the ESC and Transmitter follow these
steps:
1. Turn on the transmitter.
2. While turning on the vehicle Press and Hold the setup button, notice the
Yellow LED is now ON solid. When the Yellow LED is on solid, you can release
the setup button.