beautypg.com

Kontron COMe-cPV2(v1.4) User Manual

Page 44

background image

Kontron microETXexpress-PV User’s Guide



40

The analog VGA graphics core, with a maximum resolution of 1400x1050 (Modules
with the N450 CPU), is integrated in the processor. Modules with the D410
and D510 CPU support 2048x1536 resolution.

LVDS Flat Panel Interface (JILI)

The Intel® Atom processor has integrated 18-bit single channel LVDS for WXGA.
The user interface for flat panels is the JUMPtec* Intelligent LVDS Interface
(JILI). The implementation of this subsystem complies with the COM Express®
specification. For additional implementation information, refer to the PICMG
COM Express® Design Guide

on the PIGMG website.

4.1.13

Ethernet Interface

The Ethernet interface on the microETXexpress®-PV COM is the Intel® 82567LM
10/100/1000 Mbit Gigabit Ethernet PHY. The GbE PHY is connected to the
GLCI/LCI of the ICH8M. The controller supports a 10/100/1000 Base-T interface
and it auto-negotiates the use of 10 Mbit/sec, 100 Mbit/sec or 1Gbit/sec
connections.

The interface supports functions such as WOL (WakeOnLAN) and PXE (Preboot
eXecution Environment) boot.

For cable lengths and terminations on your baseboard, refer to the PICMG COM
Express® Design G

uide on the PICMG website.

Configuration

The Ethernet controller is a PCI Express bus device. The BIOS allocates the
required system resources during the configuration of the PCIe device.

4.1.14

SPI Bus Interface

The Serial Peripheral Interface (SPI) signals are connected to the Intel®

ICH8M hub with pins that were previously reserved on the COM Express®
connector. The SPI interface can be used to connect one carrier board
devices, including external BIOS flash memory. The implementation of this
subsystem complies with the COM Express® specification. For additional
implementation information, refer to the PICMG COM Express® Design Guide on

the PICMG website

4.1.15

LPC Bus Interface

The Low Pin Count (LPC) interface signals are connected to the Intel® ICH8M.
The LPC low-speed interface can be used for peripheral circuits. For example,