Kontron VM162 - Manual (Page 57)

VM162/VM172 Chapter 2 Functional Description
Juli 23, 1997 Page 2- 35 © PEP Modular Computers
2.10.12 IP Connectors
The figure above shows the position of IPa and IPb on the VM162/177. Each IP is plugged into the board
via a pair of 50-pin IP connectors. The rear one (near to the VMEbus connector) connects the IP bus and
control signals whereas the other one (near to the frontpanel) carries the IP I/O signals.
The IP I/O signals are routed from the 50-pin IP I/O connector to a 50-pin flatcable connector and also
to the 50-pin frontpanel DSUB connector. There is a one-to-one correspondance between the pin (si-
gnal) numbers between the IP I/O connector, flatcable connector and DSUB connector.
VME Connector VME Connector
VME P2
IPb
VME P1
IPa
IPb bus IPa bus
IPa I/O Conn. IPb I/O Conn.
IPa I/O Flat Cable Conn.
IPb I/O Flat Cable Conn.
IPb I/O DSUB IPa I/O DSUB