EFCO 8800 Series Assembly Instructions Vol.1 - Manual (Page 31)

EFCO 2009 Page 31
Series 8700 / 8800 Unitized Curtain Wall Assembly Instructions - Volume 1
FM18
17. Apply the FM18 jamb mullion spacers to jamb mullions only. Spacers will be located at horizontals as shown in Figure 16 and 18, and on each end of the
jamb mullion. FM18 jamb spacers at horizontal locations must be applied before frame assembly and after the frame pads have been applied. (See
Figures 16 and 18).
18. The FM18 jamb spacers will be screwed to the frame with (2) SFQ5 (HWH) at horizontal or spandrel areas. Use (2) STD0 (PHFH) at vision areas (See
Figures 17 and 19) STD0 should be finished to match the framing members.
Section 3 - Unit Frame Assembly : A. Mullion Subassembly
Frame pad at
horizontal
locations only
FM18
STD0
SFQ5
Figure 18
Figure 16 Figure 17
Figure 19