HP 39g Graphing Calculator - Manual (Page 237)

Stat-One and Stat-Two commands
The following commands are used for analysis of one-
variable and two-variable statistical data.
Stat-One commands
D01VSTATS
SETFREQ
Calculates STATS using datasetname and stores the results in
the corresponding variables: NE, TotE, MeanE, PVarE,
SVarE, PSDev, SSDev, MinE, Ql, Median, Q3, and MaxE.
Datasetname can be HI, H2,..., or H5. Datasetname must
define at least two data points,
DOIVSTATS datasetname
Defines datasetname frequency according to column or value,
Datasetname can be HI, H2,,,,, or H5, column can be C0-C9
and value can be any positive integer,
SETFREQ datasetname; column
SETFREQ definition; value
SETSAMPLE
Defines datasetname sample according to column.
Datasetname can be H1-H5, and column can be CO-C9,
SETSAMPLE datasetname; column
Stat-Two commands
D02VSTATS
SETDEPEND
SETINDEP
Calculates ST ATS using datasetname and stores the results in
corresponding variables: MeanX, EX, EX2, MeanY, EY,
EY2, EXY, Corr, PCov, SCov, and RELERR, Datasetname
can be SI, S2,,,,, or S5, Datasetname must define at least four
pairs of data points,
D02VSTATS datasetname
Defines datasetname dependent column. Datasetname can be
SI, S2, ,,,, or S5 and column can be C0-C9,
SETDEPEND datasetname; column
Defines datasetname independent column. Datasetname can
be SI, S2,,,,, or S5 and column can be C0-C9,
SETINDEP datasetname; column
Programming 15-29