HP 39g Graphing Calculator - Manual (Page 205)

To label parts of a
sketch
To create a set of
sketches
To store into a
graphics variable
Press and type the text in the edit line. To lock the
Alpha shift on, press (for uppercase) or |
SHIFT |E^B
(for lowercase).
To make the label a smaller character size, turn off SE3
before pressing tMrj. (BB is a toggle between small and
large font size). The smaller character size cannot display
lowercase letters.
2. Press Ha.
3. Position the label where you want it by pressing the 0
B-B-IZl
keys.
4. Press 03 again to affix the label.
5. Press MMilSI to continue
drawing, or press
[ HOME 1 to exit Sketch
/
KTi III iiii I—n^watinratBi
You can create a set of up to ten sketches. This allows for
simple animation.
• After making a sketch, press i;i4gia to add a new, blank
page. You can now make a new sketch, which becomes
part of the current set of sketches.
• To view the next sketch in an existing set, press
Hold lg;Tl4j down for animation.
• To remove the cun-ent page in the current sketch series,
press
I
DEll.
You can define a portion of a sketch inside a box, and then
store that graphic into a graphics variable.
1. In the Sketch view, display the sketch you want to copy
(store into a variable).
2.
Press
am.
3. Highlight the variable name you want to use and press
4. Draw a box around the portion you want to copy: move
the cursor to one corner, press 03, then move the cursor
to the opposite comer and press 03.
Notes and sketches 14-5