Dell KVM 1081AD/ KVM 2161AD - Manual (Page 35)

Installation xxx | xxx 27
1 Locate the SIPs for your SCS.
2 If you are using a PS/2 SIP connection, attach the color-coded ends of the
SIP cable to the appropriate keyboard, monitor, and mouse ports on the
first device you will be connecting to this SCS. If you are using a USB
connection, attach the plug from the SIP to the USB port on the first
device you will be connecting to this SCS.
3 To the RJ-45 connector on the SIP, attach one end of the CAT 5 cabling
that will run from your SIP to the SCS. See "SIP Connection" on page 28.
4 Connect the other end of the CAT 5 cable to the desired ARI port on the
back of your SCS.
5 Repeat steps 2-4 for all devices you wish to attach.
NOTE: Turn off the switch before servicing. Always disconnect the jumper cord from
the power source.
NOTE: In addition to Dell SIPs, the switch may also be connected to devices using
Avocent IQ modules, including Sun IQ modules.