Dell C2660dn Color Laser Printer - Manual (Page 180)

Job Time-out
Purpose:
To specify the amount of time the printer waits for data to arrive from the computer. The print job is cancelled if the time-out
time is exceeded.
Values:
Off Disables the job time-out.
On * 30 seconds * Sets the time the printer waits for data to arrive from the computer.
Available Range:
5–300 seconds
System Settings
Use System Settings to configure the power saving mode, warning tones, time-out duration, display language,
and job log auto print settings.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Power Saver Timer
CAUTION: If the Power Off Timer feature is set and the power is turned off, stored data in RAM Disk is cleared.
Purpose:
To specify the time for transition to power saver mode.
Values:
Sleep 10 minutes * Specifies the time taken by the printer to enter Sleep mode after it
finishes a job.
Available Range: 1–30 minutes
Deep Sleep 20 minutes * Specifies the time taken by the printer to enter Deep Sleep mode
after it has entered Sleep mode.
Available Range: 1–30 minutes
Power Off Timer *1 Auto Detect * 180 minutes *
Detects whether the printer is connected to a network via Ethernet
or wireless. If the printer is connected to a network, Power Off
Available Range:
Timer is disabled. If the printer is not connected to a network
60–1440 minutes
(connected via USB or Wi-Fi Direct), the printer automatically
turns off after the specified time has elapsed. Specify the time it
takes to automatically turn off the printer after it has entered Deep
Sleep mode.
On 180 minutes * Specifies the time it takes to automatically turn off the printer after
it has entered Deep Sleep mode.
Available Range:
60–1440 minutes
Off Disables Power Off Timer.
*1 Power Off Timer feature is available only in certain regions.
When you specify 1 minute for Sleep, the printer enters power saver mode 1 minute after it finishes a job. This
uses much less energy, but requires more warm-up time for the printer. Specify 1 minute if your printer shares an
electrical circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. In most circumstances, this keeps the printer ready to operate
with minimum warm-up time.
Select a value between 1 and 30 minutes for power saver mode if you want a balance between energy consumption
and a shorter warm-up period.
Understanding the Printer Menus 178