Dell Metered PDU LED - Manual (Page 15)

USER’S GUIDE
Mete
red Rac
k
PDU
12
 Function button • To manually display the current for each phase,
repeatedly press the button. The current displays
for 30 seconds or until you press the button again.
(This functionality is not available for single-phase
Rack PDUs.)
• To display the IP address, press and hold for five
seconds until IP appears; then release. On the
LED display, the address will appear two digits at
a time and then the cycle will repeat.
• To invert the display, press and hold for ten
seconds until the AA pattern appears. Continue
holding the button until AA is oriented as desired
then release the button.
 10/100 Base-T Connector Port for connecting the Rack PDU to the network.
 10/100 LED See 10/100 LED .
 Network Status LED See Network Status LED .
 Temp/Humidity sensor port Port for connecting a Rack PDU Temperature
Sensor (G853N) or a Rack PDU Temperature/
Humidity Sensor (H621N).
 RJ-45 Serial Port Port for connecting the Rack PDU to a terminal
emulator program for local access to the command
line interface. Use the supplied serial cable.
 Reset Button To restart the interface of the Rack PDU without
affecting the outlets, press and release the Reset
button.
Item Function