Dell PowerVault NX200 User Manual
Page 38
38
About Your System
Caution!
NVRAM_CLR jumper
is installed on
system board
NVRAM_CLR jumper is
installed in the clear setting.
CMOS has been cleared.
Move the NVRAM_CLR
jumper to the default
position (pins 3 and 5).
See Figure 6-1 for jumper
location. Restart the
system and re-enter
the BIOS settings. See
CPU set to
minimum
frequency.
The processor speed may be
intentionally set lower for
power conservation.
If not an intentional setting,
check any other system
messages for possible causes.
CPU x installed
with no memory.
Memory modules are
required but not installed in
the indicated processor’s
memory slots.
Install memory modules for
the processor. See
Current boot mode
is set to UEFI.
Please ensure
compatible
bootable media is
available. Use
the system setup
program to change
the boot mode as
needed.
The system failed to boot
because UEFI boot mode
is enabled in BIOS and
the boot operating system
is non-UEFI.
Ensure that the boot mode
is set correctly and that
the proper bootable media
is available. See "Using the
Decreasing
available memory
Faulty or improperly
installed memory modules.
Reseat the memory modules.
Table 1-2. System Messages
(continued)
Message
Causes
Corrective Actions
book.book Page 38 Monday, August 9, 2010 3:07 PM