Dell PowerVault NX200 User Manual
Page 48
48
About Your System
Unable to launch
System Services
image. System
halted!
System halted after
F10 keystroke because
System Services image
is either corrupted in the
system firmware or has
been lost due to system
board replacement.
Restart the system and
update the Unified Server
Configurator repository to
the latest software to restore
full functionality. See the
Unified Server Configurator
user documentation for more
information.
Unexpected
interrupt in
protected mode
Improperly seated
memory modules or
faulty keyboard/mouse
controller chip.
Reseat the memory modules.
Memory" on page 137. If the
problem persists, see
Unsupported CPU
combination
Unsupported CPU
stepping
detected
Processor is not supported
by the system.
Install a supported processor.
Unsupported
DIMM detected.
The following
DIMM has been
disabled: x
Invalid memory
configuration. The system
will run but with the
specified memory
module disabled.
Ensure that the memory
modules are installed in a
valid configuration. See
Unsupported
memory
configuration.
DIMM mismatch
across slots
detected:
x,x,...
Invalid memory
configuration. Memory
modules are mismatched
in the specified slots.
Ensure that the memory
modules are installed in a
valid configuration. See
Table 1-2. System Messages
(continued)
Message
Causes
Corrective Actions
book.book Page 48 Monday, August 9, 2010 3:07 PM