Dell PowerVault NX200 - Manual (Page 26)

26 About Your System
E1410 System Fatal
Error
detected.
A fatal system error has
been detected.
Check LCD for additional
scrolling messages. Remove
AC power to the system for
10 seconds and restart the
system.
If the problem persists,
see "Getting Help" on
page 157.
E1414 CPU # temp
exceeding
range. Check
CPU heatsink.
Processor is out
of acceptable
temperature range.
Ensure that the processor
heat sink is properly
installed. See
"Troubleshooting the
Processor" on page 144 and
"Troubleshooting System
Cooling Problems" on
page 136.
E1418 CPU # not
detected.
Check CPU is
seated
properly.
Processor is missing or bad,
and the system is in
an unsupported
configuration.
Ensure that the processor is
properly installed.
See "Troubleshooting the
Processor" on page 144.
E141C Unsupported
CPU configur-
ation. Check
CPU or BIOS
revision.
Processor is in an
unsupported
configuration.
Ensure that your processor
matches and conforms to
the type described in the
processor technical
specifications outlined in
your system’s Getting
Started Guide.
E141F CPU #
protocol
error. Power
cycle AC.
The system BIOS has
reported a processor
protocol error.
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 157.
Table 1-1. LCD Status Messages (continued)
Code Text Causes Corrective Actions
book.book Page 26 Monday, August 9, 2010 3:07 PM