Dell PowerVault NX200 - Manual (Page 30)

30 About Your System
E1717 CPU #
internal
error. Review
& clear SEL.
The system BIOS has
determined that the
processor has had an
internal error.
Check the SEL for
more information, and
then clear the SEL.
Remove AC power to the
system for 10 seconds,
and restart the system.
If the problem persists,
see "Getting Help" on
page 157.
E171F PCIe fatal
error on Bus
## Device ##
Function ##
The system BIOS has
reported a PCIe fatal error
on a component that
resides in PCI
configuration space at
bus ##, device ##,
function ##.
Remove and reseat the
PCIe expansion cards.
If the problem persists,
see "Troubleshooting
Expansion Cards" on
page 143.
E1810 Hard drive ##
fault. Review
& clear SEL.
The specified hard drive
has experienced a fault.
See "Troubleshooting a
Hard Drive" on page 141.
E1812 Hard drive ##
removed.
Check drive.
The specified hard drive
has been removed from
the system.
Information only.
E1A1D Control panel
USB cable not
detected.
Check cable.
USB cable to the
control panel is
missing or bad.
Reseat the cable. If the
problem persists,
replace cable.
If the problem persists,
see "Getting Help" on
page 157.
E2010 Memory not
detected.
Inspect
DIMMs.
No memory was
detected in the system.
Install memory or reseat
the memory modules.
See "Installing Memory
Modules" on page 100 or
"Troubleshooting System
Memory" on page 137.
Table 1-1. LCD Status Messages (continued)
Code Text Causes Corrective Actions
book.book Page 30 Monday, August 9, 2010 3:07 PM