Edge Lighting TruLine 1.6A, 24VDC - Plaster-In LED system - Manual (Page 9)

9
11: Snap the lens into the assembled channel BEFORE
marking and cutting. This ensures a good fit when installed. 8: Remove the trap door frame from the junction box.
9: Insert the joiner bars halfway into the channel trap door
frame. Tighten the two #4-40 set screws on each joiner
bar with a 0.05" Allen wrench.
10: Slide the other section of channel onto the joining bars and
tighten the remaining set screws.
MARK CHANNEL AT MEASURED LENGTH
12: Mark the assembled channel and lens lengths using the measurements taken in Steps 6 and 7.
45°
45°
13: Miter cut each section of assembled channel and lens to match the corner angle. In a 90° corner installation as shown, each
channel section is cut at a 45° angle to form a complete corner.
SIDE VIEW
Z1 Z2
Z3
Z4
9
10
CHANNEL
JOINER
BAR
TRAP DOOR
FRAME
11
CHANNEL
LENS
12
13
13