Edge Lighting TruLine 1.6A, 24VDC - Plaster-In LED system - Manual (Page 15)

22: Place both power connector into the power feed end cap
by rotating them 90° to seat.
23: Insert the #4-40 Torx screws through the end cap holes and
thread into the power end of the TruLine 1.6A channel.
24: Tighten the end cap to the channel using the provided T10
Torx screwdriver.
20: Slide the other section of mitered channel onto the 90°
joining brackets and tighten the remaining M4 set screws
with a 1.5MM Allen wrench. 21: Slide the take-up box onto the non-power channel end and
tighten the M4 set screws with a 1.5MM Allen wrench.
#6 SCREW
25: Using the mark locations on the drywall, carefully make
a hole to channel using the provided square drill with
counter sink bit.
26: Secure the channel to the studs/mounting straps through
the drywall with the #6 screws using the provided square
recess bit.
27: Secure the Trap Door channel section to the junction
box with the supplied screw.
20
21
22
23
25
26
CHANNEL
TRAP DOOR
90° JOINING
BRACKET
CHANNEL
CHANNEL CHANNEL
POWER FEED
END CAP
POWER
CONNECTOR
TORX SCREW
POWER FEED
END CAP
Z27 Z28
Z29 Z30
Z31
TAKE-UP BOX
24
15