Edge Lighting Vase - Manual

FJ-VASE1-_
A
Installation Instructions for Fast Jack Vase Round and Square
Install the Lamp
1
904-FJ-VASE-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
1: Push the LED lamp pins completely into the socket holes.
© 2014 Edge Lighting. All Rights Reserved.
1
SAVE THESE INSTRUCTIONS!
IMPORTANT SAFETY INSTRUCTIONS
- Use this fixture indoors only.
- This product can be dimmed with a standard low-voltage
electronic dimmer.
- This product must be installed by a qualified electrician.
- Before beginning any electrical work, ensure that
power to the junction box is turned OFF.
FJ-VASE2-_
NOTE: Use MAXIMUM 3 Watt 12 VAC LED
Bi-pin lamp.
Adjust the Fixture Height
B
1: Cut the coaxial cable to the desired height (H) with a sharp
cutter. The overall fixture height is measured from the
bottom of the glass shade to the end of the coaxial cable.
H
1
C
M4 SET SCREW M3 SET
SCREW
1.5MM ALLEN
WRENCH 2MM ALLEN
WRENCH
2
3
COAXIAL FIXTURE
CONNECTOR
2: Loosen the M4 set screw on base of the coaxial fixture
connector with the 2mm Allen wrench provided. Do not
remove this set screw.
3: Remove the M3 set screw on tip of the connector with the
1.5mm Allen wrench provided.
LED
BI-PIN
LAMP
SOCKET