Edge Lighting Vessel 6 - Manual

Installation Instructions for Vessel 6 Suspension
904-VESS-S-6-01
SAVE THESE INSTRUCTIONS!
- This product can ONLY be ceiling mounted.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
IMPORTANT INFORMATION
Install the Fixture
VESS-S-6-WH 1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
A
H
CANOPY
1: Determine the desired fixture height (H), from the bottom of
the shade to the top the canopy.
1
2: Insert the cord into the strain relief, canopy, and crossbar
assembly.
3: Adjust the fixture height, and mark a line when the desired
height is achieved.
1
© 2013 Edge Lighting. All Rights Reserved.
SHADE
CORD
B
CROSSBAR
ASSEMBLY
STRAIN RELEIF
2
MARK LINE
C
4"
CANOPY
CORD
CORD DETAIL
FABRIC
INSULATION
WIRES
6"
5
4
4: Leave 6" of the crossbar assembly behind the canopy for
power connections. Cut the excess cord.
5: From the end of the cord remove 4" of the cord
fabric/insulation. Make sure not to nick the inner
wires and trim off the cutout insulation.
6: Strip 1/4" of the insulation from the end of the wires.
CANOPY
3