Edge Lighting K2 LED - Manual

FJ-K2-12-SN
Installation Instructions for Fast Jack K2 LED Pendant
904-FJ-K2-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2012 Edge Lighting. All Rights Reserved.
1
Adjust the Fixture Height
A
H
1: Cut the coaxial cable to the desired height (H) with a sharp
cutter. The overall fixture height is measured from the
bottom of the metal shade to the end of the coaxial cable.
B
M4 SET SCREW M3 SET
SCREW
1.5MM ALLEN
WRENCH 2MM ALLEN
WRENCH
2
3
COAXIAL FIXTURE CONNECTOR
2: Loosen the M4 set screw on base of the coaxial fixture
connector with the 2mm Allen wrench provided. Do not
remove this set screw.
3: Remove the M3 set screw on tip of the connector with the
1.5mm Allen wrench provided.
METAL SHADE
COAXIAL CABLE 1
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- The product is intended to be used with Edge Lighting
Monorail systems only.
IMPORTANT INFORMATION
C
CONICAL NIPPLE
STRAIN RELIEF TUBE
COAXIAL CABLE
4
4: Feed the coaxial cable through the conical nipple and flared
side of the strain relief tube. Slide the conical nipple and
strain relief tube down the coaxial cable.
D
COAXIAL CABLE
5
5: Feed the coaxial cable into the coaxial fixture connector. The
coaxial cable will come to a stop point.