Edge Lighting Harley - Manual

SAVE THESE INSTRUCTIONS!
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
M-HAR-4_
FJ-HAR-4_
M2-HAR-4_
- This product is ETL listed for indoor dry locations.
- This product is not restricted to certain height installation.
It is approved to be used at any height above the floor.
- Applicable accessories are Hexcell Louver, Glass Lenses,
Gobo Holder, MR16 Snoot and Scope.
A
SOCKET
SOCKET POST
THUMB SCREW LAMP
1
2
1: Loosen the thumb screws on the socket post and pull the
socket back.
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
Use MAX 75 Watt, Type MR16 Front Glass Cover Halogen
Lamp.
2: Push the lamp pins completely into the socket holes.
HEXCELL LOUVER
OR GLASS LENS
SOCKET POST
THUMB SCREW
RING
RING THUMB
SCREW
3
4
5
B
3: Place optional glass lens or hexcell louver into the ring.
4: Slide the socket forward to secure the lamp and accessory
against the ring, and tighten the thumb screws.
5: To rotate the fixture, loosen the ring thumb screws. Rotate
the ring to the desired position and then tighten the thumb
screws.
Harley Installation Instructions for
Install the Lamp
1
904-HARLEY-03
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Use this fixture indoors only.
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth. Oil from skin
may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Do not operate the luminaire with a missing or damaged
shield.
- Turn power off and allow to cool before replacing lamp.
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT INFORMATION
© 2009 Edge Lighting. All Rights Reserved.