Edge Lighting Scope LED Pendant - Manual

FJ-SCLP-_
Installation Instructions for Fast Jack Scope LED Pendant
1
904-FJ-SCLP-05
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2011 Edge Lighting. All Rights Reserved.
B
M4 SET SCREW M3 SET
SCREW
1.5MM ALLEN
WRENCH 2MM ALLEN
WRENCH
2
3
COAXIAL FIXTURE CONNECTOR
Adjust the Fixture Height
A
1: Cut the coaxial cable to the desired height (H) with a sharp
cutter. The overall fixture height is measured from the
bottom of the metal shade to the end of the coaxial cable.
H
2: Loosen the M4 set screw on base of the coaxial fixture
connector with the 2mm Allen wrench provided. Do not
remove this set screw.
3: Remove the M3 set screw on tip of the connector with the
1.5mm Allen wrench provided.
1
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- The product is intended to be used with Edge Lighting
Monorail systems only.
- The product is safe to be used in food processing or
consuming areas without the glass lens. It is safe to use
the thermoplastic lens in the fixture. For more information
see "Adjusting the Light Beam" section.
IMPORTANT INFORMATION
4: Feed the coaxial cable through the conical nipple and flared
side of the strain relief tube. Slide the conical nipple and
strain relief tube down the coaxial cable.
C
CONICAL
NIPPLE
STRAIN RELIEF TUBE
COAXIAL CABLE
4
D
COAXIAL CABLE
5
5: Feed the coaxial cable into the coaxial fixture connector. The
coaxial cable will come to a stop point.