Edge Lighting White Night & Dark Night - Manual

FJ-NIGHT-_
Installation Instructions for White & Dark Night
1
904-FJ-NIGHT-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2011 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations and
approved to be used at any height above the finished
floor.
IMPORTANT INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Use this fixture indoors only.
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Do not operate the luminaire with a missing or damaged
shield.
- Turn power off and allow to cool before replacing lamp.
GLASS
SHADE
THREADED
STUD
SOCKET
ASSEMBLY
A
LAMP
SOCKET
CAUTION: To reduce risk of a burn or electrical shock during
lamping, disconnect the power to the fixture.
Use MAX 35 Watt, Type Bi-Pin Halogen Lamp.
1: Push the lamp pins completely into the socket holes.
2: Push the lamp shield onto the spring clips.
B
3: Place the socket assembly into the glass shade.
4: Align the socket assembly holes with the glass shade holes.
Finger tighten the three threaded studs through the glass
shade holes completely into the socket holes to secure the
glass shade in place.
SOCKET
ASSEMBLY
LAMP
SHIELD
SPRING
CLIP
1
2
NOTE: Use a soft cloth and fingers to install the lamp.
4 4
3
Install the Shade Lamp and
SOCKET
ASSEMBLY