Edge Lighting Jelly - Manual

FJ-JELLY-__-SN-__
A
Installation Instructions for Fast Jack Jelly
Install the Lamp
1
904-FJ-JELLY-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
1: Loosen the post at the top of the fixture and carefully slide
the socket assembly out of the glass shade.
2: Loosen and remove the metal shade from the socket
assembly.
3: Align the MR11 lamp pins to with the socket holes. Push the
lamp pins completely into socket holes.
4: If necessary, place any optical lenses (or optional crystal
accessory)inside the metal shade before replacing the metal
shade to the socket assembly.
5: Slide the glass shade onto the socket assembly and tighten
the post to secure.
© 2014 Edge Lighting. All Rights Reserved.
1
SAVE THESE INSTRUCTIONS!
IMPORTANT SAFETY INSTRUCTIONS
- Use this fixture indoors only.
- This product must be installed by a qualified electrician.
- This product is used with Monorail, Monorail 2 Circuit, and
Fast Jack canopy systems.
- Make sure power to the system is turned OFF before
installing the fixture.
NOTE: Use MAXIMUM 3 Watt 12 VAC MR11
LED lamp or MAXIMUM 20 Watt 12 or 24VAC
MR11 halogen lamp.
C
M4 SET SCREW M3 SET
SCREW
1.5MM ALLEN
WRENCH 2MM ALLEN
WRENCH
2
3
COAXIAL FIXTURE
CONNECTOR
2: Loosen the M4 set screw on base of the coaxial fixture
connector with the 2mm Allen wrench provided. Do not
remove this set screw.
3: Remove the M3 set screw on tip of the connector with the
1.5mm Allen wrench provided.
Adjust the Fixture Height
B
1: Cut the coaxial cable to the desired height (H) with a sharp
cutter. The overall fixture height is measured from the
bottom of the glass shade to the end of the coaxial cable.
H
1
COLLET
SOCKET
ASSEMBLY
MR11
BI-PIN
LAMP
GLASS
SHADE
METAL
SHADE
CRYSTAL
ACCESSORY
(OPTIONAL)
2
3
4