Edge Lighting TruLine .5A, 24VDC - Plaster-In LED System - Manual (Page 13)

13
35
NOT INSTALLED
CORRECTLY
35: Snap the lens back onto the channel sections. Ensure lens is fully seated.
35
Z17
Section Five: Zig Zag Installation
CORRECT
JUNCTION
BOX
1 MOUNTING
BRACKET
PHILLIPS
SCREW
ADJUSTABLE
MOUNTING BAR
1: Mount each adjustable mounting bar to one side of the
junction box and secure them with the mounting brackets
and two Phillips screws provided.
2: Place the lips on the adjustable mounting bars against
the studs. Secure the adjustable bars to the studs with
the eight #8 screws.
3: Install conduit (if required by local electrial code) and run
low-voltage power wires to the junction box.
NOTE: The adjustable mounting bars mount to studs that
are spaced 13" to 24" apart.
INSTALLATION
DIRECTION
ADJUSTABLE
MOUNTING BAR
STUD #8 SCREW
2
3
JUNCTION
BOX
CONDUIT W/
LOW-VOLTAGE WIRES
6" FIXED
JAB SAW
4: Cut a section of drywall using a 6" fixed jab saw or other
appropriate tool to expose the mounting plate area.
4
5: Insert the joiner bars halfway into the channel trap door
frame. Tighten the two #4-40 set screws on each joiner bar
with a 0.05" Allen wrench.
6: Slide the other section of channel onto the joining bars and
tighten the remaining #4-40 set screws with a 0.05" Allen
wrench.
5
6
JOINER
BAR
TRAP DOOR
FRAME
Z18 Z19
Z20
Z21