Drucker Diagnostics Paralens Advance - Manual (Page 8)

Section 2
Installation Procedures
2.1 INSTALLATION SERVICE
The Autoread Plus System will normally be installed
by a QBC Diagnostics Inc. representative. If
necessary, contact your distributor or the nearest
office of QBC Diagnostics Inc. to arrange for
installation service.
2.2 AUTOREAD PLUS SYSTEM COMPONENTS
Test accessories included with the Autoread Plus
System are:
• USB Printer (U.S. Only)
• USB Printer Cable
• Software Cartridge
• QBC Pipetter & AccuTube Spacer
• Small screwdriver for adjusting displays
• Calibration check rod
• Forceps for handling floats
• Workstation
• Operator’s Manual (this document)
Test disposables for QBC hematology and optional
accessories are listed in Appendix C.
2.3 SETUP PROCEDURES
2.3.1 Inserting Software Cartridge
(Note: For directions on installing software cartridges
with USB compatibility, consult the included insert
labeled “IMPORTANT INFORMATION”.)
Install the software cartridge in the instrument prior
to operation and while the Power switch of the unit
is
Off. Referring to Figure 2-1, orient the cartridge
so that the label faces up; then insert the cartridge
into the slot in the back panel. Push in firmly until
the cartridge “finger” is mated to the circuit board
connector.
Figure 2-1.
Inserting Software Cartridge into Analyzer
CAUTION
Damage to electronic circuitry can occur
if power is on while the cartridge is being
inserted into or removed from the analyzer.
Always be sure the power switch is off before
installing or removing the cartridge.
2-1
POWER
SWITCH
“OFF”
LABEL UP
System
Part No.
Analyzer
Part No.
Power Pack
Part No.
QBC Capillary
Centrifuge
Part No.
428605 429576 424590 425740