Drucker Diagnostics Paralens Advance User Manual
Page 43

Step 2: Rock the AccuTube to Mix
Note: Do not allow the blood to touch the
AccuTube rubber stopper while performing this
step. If blood stops moving, loosen or remove
the stopper and finish mixing, then re-insert the
stopper.
Hold the AccuTube in the center. Rock the
AccuTube back and forth at least 5 times.
Move blood end to end to mix well with orange
coating.
Step 3: Seat the Stopper
Turn the AccuTube upright. Hold the AccuTube
near the stopper end. Seat the stopper by
pressing down firmly on a hard surface. At this
point, the blood can touch the stopper.
Step 4: Insert the Float
Note: Do not touch the floats with your fingers.
Slide the open end of the AccuTube over a
float until the float is partially inserted. Gently
lift the AccuTube up and out of the SoftGrip.
Push float against the back of the package to
fully insert.
Step 2
Rock 5 Times
Step 3
Seat Stopper
Step 4
Insert Float
6-3
A
B
A + B = 1 ROCK