Drucker Diagnostics Paralens Advance - Manual (Page 13)

2.4 INITIAL ADJUSTMENTS TO ANALYZER
(continued)
2.4.4 Setting Printout Format
When the QBC Autoread Plus analyzer is equipped
with software that incorporates the Hematology
Diagnostic Reminder or HDR program, the test
printout format can be pre-selected from a menu of
print options.
Using the [MODE] key, advance the display to the
OPTIONS MODE (see opposite); access the SET
PRINT FORMAT display by means of the [5] or [6]
key, followed by the PRINTOUT OPTIONS display
using the [NEXT] key.
Use the [5] or [6] key to preview the print options.
Pre-program the analyzer to print out test results in
one of three formats – or opt for no printout at all.
Short vs Long HDR’s differ in diagnostic detail, the
Short form providing a summary or abbreviated
report of the test result analyses. Press the [NEXT]
key to enter the desired selection. Upon pressing
[NEXT] to set the format, the operator will be given
the choice of obtaining results on a printed page or
label. After the page or label selection, the display
will return automatically to the SET PRINT FORMAT.
Exit by means of the [MODE] key.
The print format set here will be the format used to
print out test results automatically after an assay is
completed.
Note: The printout format can be temporarily
changed after the completion of a test.
See procedures in Section 4.2.3.
CAUTION
Be sure printer is approved for use and
compatible with analyzer before connection to
instrument.
MESSAGES MESSAGES
AVAILABLE WITH
TEST VALUES ONLY
2-6
MESSAGES
PRESS [5] TWICE
MESSAGES
PRESS [NEXT]
MESSAGES
MESSAGES
MESSAGES
MESSAGES
MESSAGES
MESSAGES
PRESS [5] PRESS [6]
MESSAGES
OPTIONS MODE
Select... [5] [6]
Printout Options
Select... [5] [6]
Autoread Plus
Set Print Format
For VALUES + SHORT
HDR, Press [NEXT]
For VALUES + LONG
HDR, Press [NEXT]
For NO PRINTOUT
Press [NEXT]
For TEST VALUES only,
Press [NEXT]
Print full page?
YES [5] NO [6]
Page Printout
Press [NEXT]
Label Printout
Press [NEXT]
Autoread Plus
Set Print Format