Drucker Diagnostics Paralens Advance - Manual (Page 38)

4.10 PRECAUTIONS AND HAZARDS
ELECTRICAL SAFETY
• Power Connections: Plug the cordsets of
the power pack, centrifuge, and printer only
into AC receptacles rated at the voltage and
frequency specified on the data plates.
• Grounding: Never remove the grounding prong
from the cordset plugs of the power pack,
centrifuge, and printer.
• Repairs: Always unplug the power cord before
attempting any repairs or service.
• Defective Cords: If a power cord or plug
is damaged, promptly request replacement
service.
HANDLING PRECAUTIONS
• Biohazards: Blood specimens may contain the
Hepatitis B Virus (HBV), Hepatitis C Virus (HCV),
Human Immunodeficiency Virus (HIV), or other
disease-causing agents. Handle all patient
specimens as potential biohazards capable
of
transmitting infection. Wear appropriate
personal protective equipment, including
gloves, when collecting and processing blood.
• QBC Tube/Centrifugation: QBC Blood Tubes
are made of glass. Be careful when handling
and preparing tubes to prevent breakage and
possible injury. Inspect QBC Tubes before
use. DO NOT use cracked or scratched tubes.
Always install the rotor cover tightly before
centrifuging blood tubes to prevent breakage.
• Position Error Message: Always use forceps
to remove tube from instrument. Carefully
follow instructions or message display to
prevent breakage of tube inside instrument.
• Tube Breakage: If a QBC tube breaks, carefully
pick up broken glass with a hemostat or other
device, using puncture-resistant utility gloves.
— If a tube breaks inside the centrifuge, wipe
the head and interior of the cover clean with
a cloth and a 1:10 dilution of chlorine bleach.
Allow to dry. Note: Do not pour water or
bleach solution into the centrifuge itself.
— If a tube breaks inside the analyzer, remove
the waste tray below the loading platform
and discard any broken glass. Clean the
waste tray with a 1:10 dilution of chlorine
bleach; then rinse with water and dry.
4-15