Drucker Diagnostics Paralens Advance - Manual (Page 11)

2.4 INITIAL ADJUSTMENTS TO ANALYZER
2.4.1 Display Contrast
Turn power on and test the calibration check rod
(see Section 2.6). Check for readability of the
displays while room light is at its normal working
level. If necessary, turn the upper CONTRAST
adjustment (Figure 2-5) with the accessory
screwdriver; clockwise darker, counterclockwise
lighter.
Use the lower CONTRAST control to adjust the
MESSAGES display.
2.4.2 Selecting Display Language
The procedures below describe how to select the
desired display language with software cartridges
that permit
multilanguage displays.
Upon powering up for the first time (i.e., with a new
cartridge), the display language will be English.
To program a different display language with
cartridges that contain multilanguage software,
proceed as follows:
a) First allow the analyzer to complete a Self-Check
Sequence (see Section 4.1.1).
b) Then press the [MODE] key until the OPTIONS
MODE SELECT 5 6 is obtained.
c) Use the [5] or [6] keys to scroll through the
following option functions:
c Set Language
c Set Units
c Set Baud Rate
c Cartridge Type
c Set Print Format
c Set Date & Time
d) Press [NEXT] when the SET LANGUAGE option
is displayed.
e) Follow the SET LANGUAGE display and key
routine shown opposite to set the desired
language.
Figure 2-5.
Display Contrast Adjustments
2-4
CONTRAST
ADJUSTMENT
FOR TEST
DISPLAYS
CONTRAST
ADJUSTMENT
FOR MESSAGE
DISPLAY
MESSAGES
PRESS [NEXT]
MESSAGES
PRESS 5OR6
MESSAGES TO SCROLL
MESSAGES
MESSAGES
MESSAGES
MESSAGES
MESSAGES
MESSAGES
MESSAGES
PRESS [NEXT] AT
DESIRED LANGUAGE
AUTOREAD PLUS
Set Language
For English...
Press [NEXT]
Set Language
Select..[ 5 ] [ 6 ]
Pentru Romani..
Apasati [NEXT]
Para Português..
Aperte [NEXT]
Polski...
Nacisn [NEXT]
Für Deutsch...
[NEXT] eingeben
Para español..
Pulsar [NEXT]
francais...
Touchez [NEXT]
Per Italiano...
premere [NEXT]